Table of Contents
Advertisement
Important
If the battery is ever removed, make sure
that battery clamp bolts are reinstalled with the bolt heads
positioned on the bottom side and the nuts on the top side.
If the clamp bolts are reversed, they may interfere with the
hydraulic tubes when shifting the cutting units.
8. Coat both battery connections with Grafo 112X (skin
over) grease, Toro Part No. 505-47, petroleum jelly, or
light grease to prevent corrosion. Slide the rubber boot
over the positive terminal.
9. Install the battery cover.
Installing the Seat
The machine is shipped without the seat assembly. Deluxe
Seat Kit, Model No. 03225 or Standard Seat Kit, Model
No. 03224, must be installed as follows:
1. Remove the screws, washers, and spacers securing the
seat mounting straps to the traction unit frame (Fig. 3).
2
Figure 3
1. Seat mounting strap (2)
2. Secure the seat mounting straps to the seat adjusters
with 4 flange nuts (standard seat) or 4 bolts, flat
washers, and flange nuts (deluxe seat) (Fig. 4). The
mounting fasteners are supplied with the seat kits.
3. Attach the seat belt to the holes on each side of the seat
with 2 bolts and lockwashers (standard seat) or 2 bolts
and locknuts (deluxe seat) (Fig. 4). All mounting
fasteners are supplied with the seat kits.
4. Position the seat and seat straps on the frame aligning
mounting holes.
5. Route the seat switch wire under the right-hand seat
strap and connect it to the appropriate seat switch
connector on the wire harness.
1
2. Spacer (2)
14
1
2
Figure 4
1. Standard seat
2. Seat adjusters
6. On the deluxe seat only, route the unused seat switch
connector back under the seat strap and secure both
wires to the rear-most hole in the seat strap (Fig. 5) with
a cable tie (cable tie supplied with seat kit).
1
Figure 5
1. Seat switch wire
7. On the standard seat only, slide the seat all of the way
forward, pull the wire to the right so that the unused
connector is positioned as shown in Figure 6, and
secure the seat switch wire to the rear-most hole in the
seat strap with a cable tie (cable tie supplied with seat
kit).
Figure 6
1. Seat switch wire
3
3. Seat belt
2
2. Cable tie
2
1
2. Cable tie
Advertisement
Table of Contents
