Body/Frame; Engine Area; Recovery Latching Point Condition; Chassis Fasteners - Can-Am Renegade Operator's Manual

BODY/FRAME

Engine Area

Check engine area for any damage
and leaks. Ensure all hose clamps
are properly secured and no hose is
cracked, kinked or otherwise dam-
aged.
Inspect muffler, battery and reservoir
fastening devices.
Check electrical connections for corro-
sion and tightness.
Replace or have damaged parts re-
paired.
Recovery Latching Point
Condition
Check tightness of fasteners. Proper-
ly retighten as necessary.

Chassis Fasteners

Check fastener condition and tight-
ness on the vehicle. Retighten as
required.
While reading this Operator's Guide, remember that :
Indicates a potential hazard that, if not avoided, could result in serious in-
jury or death.
_____________________
120

Seat Fasteners

Remove seat and check latch mecha-
nism and pin for wear. See an autho-
rized Can-Am dealer for parts replace-
ment if damaged.
Vehicle Cleaning and
Protection
Never use a high pressure washer to
clean the vehicle. USE LOW PRES-
SURE ONLY (like a garden hose).
High pressure can cause electrical or
mechanical damages.
Painted parts which are damaged
should be properly repainted to pre-
vent rust.
When required, wash the body with
hot water and soap (only use mild de-
tergent). Apply non-abrasive wax.
CAUTION: Never clean plastic parts
with strong detergent, degreasing
agent, paint thinner, acetone, etc.
WARNING