Table of Contents
Advertisement
HIKVISION DS-8104AH(L)I-S User‟s Manual
Serial Interception
The Serial Interception is used for capturing the card No. and other information by intercepting the data from serial port
connected.
1.
Enter ATM Setting menu, shown in Figure 9. Click Menu > Setting >ATM to enter ATM Settings menu.
2.
Click the ATM Enable checkbox to enable ATM function, and then select the connection type to Serial
Interception.
Figure 9. ATM Settings Menu
Note:
The Serial Interception and Serial Protocol cannot be selected simultaneously.
3.
ATM Type Settings, shown in Figure 9. The ATM type can be set to DIEBOLD, DRS918 or NCR_2, or
customized by clicking the Set button beside More Settings to enter the ATM Type Settings menu.
4.
Set the Data Packet in the menu. Please refer to step2 in section Network Interception for the same
instructions. After completion of Data Packet settings, click the Trading Info item to enter the menu.
5.
Trading Information Settings: Set the main type, with Card No., Trade Action, Trade Amount and Serial No.
selectable.
6.
Set the location, length, overlay position of the selected main type. If required, input the characters beside
Display Prefix to add a prefix to the selected main type. After completion of Trading Info settings, click the
Trigger Channel item to enter the menu.
Note:
When the main type is set to Trade Action, user may select the corresponding sub-type, with the InCard,
OutCard, Overlay, Query, Withdraw, Deposit, Change Password and Transfer options selectable.
7.
Set the Location of the main type. Click the Set button beside Location to enter the menu.
8.
Select the location of the card No. in the message to Fixed Offset or Token Offset. In token offset mode,
user may set the identifier (ASCII/HEX) and extra offset to determine the position of the content in the
message, as well as set the multiplier of the identifier.
9.
Set the Length of the main type. Click the Set button beside Length to enter the menu.
10. Set the length of the card No. to Fixed Length, Variable Length or Auto Length. In variable length mode,
user may set the End Character to determine the length of the card No. In auto length mode, user may set the
length value and position to obtain the card No. length in from the message.
Note:
No Length can be set if the main type is selected to Trade Action.
11. Set the Overlay Position of the main type. This menu is used for setting the overlay position of the card No.,
90
Advertisement
Table of Contents
