Led Indicators - Meteor Manuale Compact 400 Plus Manual

6.3 LED Indicators

There are three LED indicators on the front panel, "READY",
"MEDIA" and "RIBBON". These indicators display the
operation status of the printer.
READY The READY indicator will remain lighted except if any
of the following conditions prevail.
- Receiving data from host.
- A fault condition.
MEDIA The MEDIA indicator will remain on for the normal
operation of the printer.
- The printer is at PAUSE state.
- Blinking – Media run out. (READY will be also
blinking.)
RIBBON ONI– under thermal transfer mode with ribbon installed.
OFF – under direct thermal mode. (No ribbon installed.)
Set by Windows driver or command.
Blinking – Ribbon run out. (READY will be also
blinking.)
Notes:
1. We suggest you make " media calibration ".
- for the first time media installation
- after change different type or size of media
2. After calibration, the printer will save the related parameters
(reflection characteristics, label length, etc.) to E
Without calibration, the incorrect media/Gap detection may
occur, especially for small-size labels (less than 20mm in
height).
2
PROM.
21
www.meteorbarcode.it - info@meteorbarcode.it
3. Before calibration, the media and ribbon must be loaded
properly and move the label sensor to correct position.
4. After self-test, the printer is at dump mode, If you need
normal operation, you must press CANCEL to restart the
printer.
Top Cover
Cover Lock
Power Switch
22