Drive System Maintenance; Adjusting The Transmission For Neutral; Adjusting The Transport Speed - Toro 04510 Greensmaster 3300 TriFlex Operator's Manual

Drive System
Maintenance
Adjusting the Transmission
for Neutral
If the machine creeps when the traction control pedal is in
the neutral position, the neutral return mechanism must be
adjusted.
1. Block up under the frame so that one of the front
wheels is off of the floor.
Note: Note: If machine is equipped with a 3–wheel
drive kit, also raise and block rear wheel.
2. Start the engine, move the throttle to Slow, and check
the front wheel that is off of the floor; it must not be
rotating.
3. If the wheel is rotating, stop the engine and proceed
as follows:
A. Loosen the nut securing the eccentric to the top
of the hydrostat (Figure 48).
1
Figure 48
1. Eccentric
B. Move the functional control lever to Neutral and
the throttle to Slow. Start the engine.
C. Rotate the eccentric until creep does not occur in
either direction. When the wheel stops rotating,
tighten the nut locking the eccentric and the
adjustment (Figure 48). Verify the adjustment
with the throttle in the Slow and Fast position.
Note: If the wheel still turns when the eccentric
is at the maximum adjustment, contact your
Authorized Service Distributor or refer to the
Service Manual for further adjustment.
2
g014616
2. Locknut

Adjusting the Transport Speed

Obtaining the Maximum Transport
Speed
The traction pedal is adjusted for maximum transport speed
at the factory, but an adjustment may be required if the pedal
reaches full stroke before it contacts the pedal stop, or if a
decrease in transport speed is desired.
To obtain maximum transport speed, put the functional
control lever in the transport position and press down on
the traction pedal. If the pedal contacts the stop (Figure 49)
before tension is felt on the cable, an adjustment is required:
1. Put the functional control lever in the transport
position and loosen the locknut securing the pedal stop
to the floor plate (Figure 49).
2. Tighten the pedal stop until it does not contact the
traction pedal.
3. Continue applying a light load on the transport pedal
and adjust the pedal stop so it contacts the pedal rod
and tighten the nuts.
Important: The tension on the cable must not be
excessive or cable life will be reduced.
1
1. Pedal stop
Reducing the Transport Speed
1. Press down on the traction pedal and loosen the
locknut securing the pedal stop to the floor plate.
2. Loosen the pedal stop until the desired transport speed
is obtained.
3. Tighten the locknut securing the pedal stop.
37
Figure 49
g015494