Installing The Steering Wheel; Activating And Charging The Battery - Toro 04510 Greensmaster 3300 TriFlex Operator's Manual

3

Installing the Steering Wheel

Parts needed for this procedure:
1 Steering wheel
1 Locknut (1-1/2 inches)
1 Washer
1 Steering wheel cap
Procedure
1. Slide the steering wheel onto the steering shaft (Figure
5).
g014687
1. Steering wheel
2. Washer
2. Slide the washer onto the steering shaft (Figure 5).
3. Secure the steering wheel to the shaft with a jam nut
and tighten it to 27 to 35 N-m (20 to 26 ft-lb) (Figure 5).
4. Install the cap to the steering wheel and secure it with a
screw (Figure 5).
4
Activating and Charging the
Battery
No Parts Required
Procedure
Use only electrolyte (1.265 specific gravity) to fill the battery
initially.
4
3
2
1
Figure 5
3. Jam nut
4. Cap
1. Remove the fasteners and battery clamp and lift out
the battery.
Important: Do not add electrolyte while the
battery is in the machine. You could spill it,
causing corrosion.
2. Clean the top of the battery and remove the vent caps
(Figure 6).
3. Carefully fill each cell with electrolyte until the plates
are covered with about 6 mm (1/4 inch) of fluid (Figure
7).
1. Electrolyte
4. Allow approximately 20 to 30 minutes for the
electrolyte to soak into the plates. Fill as necessary to
bring the electrolyte to within about 6 mm (1/4 inch)
of the bottom of the fill well (Figure 7).
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks
and flames away from battery.
5. Connect a 2 to 4 amp battery charger to the battery
posts. Charge the battery for 2 hours at 4 amps or for
14
Figure 6
Figure 7