Diagnostics System; Diagnosing The Service Indicator Light; Storage - Toro 04510 Greensmaster 3300 TriFlex Operator's Manual

Diagnostics System

Diagnosing the Service
Indicator Light
The service indicator light illuminates in the event of a
fault in the machine. When this light is on, you can access
the computer codes to diagnose the problem by entering
diagnostic mode. In diagnostic mode, the service indicator
light will flash a number of times giving you the error code
that you or your distributor can use to identify the problem.
Note: The engine cannot be started in diagnostic mode.
Entering Diagnostic Mode
1. Stop the machine, set the parking brake, and turn the
ignition key to Off.
2. Move the Functional Control Lever to the Transport
position.
3. Ensure that the Backlap lever is set to Forward (F).
4. Get off of the seat.
5. Hold the Raise/Lower Mow Control in the Raised
position.
6. Turn the ignition switch to the Run position.
7. Count the codes as they begin to flash (you may
release the Raise/Lower Mow Control once they begin
flashing).
When finished, turn the key to the Off position to exit
diagnostic mode.
Determining the Error Code
The system will display the last 3 faults that occurred in the
last 40 hours. It displays the faults through a series of blinking
lights, as follows:
•
If there are no faults, the light with blink steadily at a
medium rate without pauses (1 Hz).
•
If there is a fault, it will first blink the tens place, followed
by a pause, followed by the ones place. For the following
examples, a # represents a blink. Examples:
– If the code is 15, the blink pattern will be #_#####
– If the code is 42, the blink pattern will be ####_##
– If the code is 123, the blink pattern will be
############_###
•
If there are more than one fault, the tens place of the next
fault will begin after a pause after the ones place of the
first fault.
Note: The system stores only the three most recent fault
codes.
For a list of error codes, refer to your Authorized Distributor
or the Service Manual.

Storage

If you wish to store the machine for a long period of time, the
following steps should be performed prior to storage:
1. Remove accumulations of dirt and old grass clippings.
Sharpen the reels and bedknives, if necessary; refer
to the cutting unit's Operator's Manual. Use a rust
preventive on bedknives and reel blades. Grease and
oil all lubrication points.
2. Block up the wheels to remove any weight on the tires.
3. Drain and replace the hydraulic fluid and filter and
inspect the hydraulic lines and fittings. Replace, if
necessary; refer to Changing the Hydraulic Oil and
Filter (page 39) and Checking the Hydraulic Lines and
Hoses (page 39).
4. All fuel should be removed from the fuel tank. Run the
engine until it stops from lack of fuel. Replace the fuel
filter; refer to Replacing the Fuel Filter (page 35).
5. While the engine is still warm, drain the oil from the
crankcase. Refill it with fresh oil; refer to Changing the
Engine Oil and Filter (page 34).
6. Remove the spark plugs, pour one ounce of SAE 30 oil
into the cylinders, and crank slowly to distribute the oil.
Replace the spark plugs; refer to Replacing the Spark
Plugs (page 35).
7. Clean dirt and chaff from the cylinder, cylinder head
fins, and blower housing.
8. Remove the battery and charge it fully. Either store
it on the shelf or on the machine. Leave the cables
disconnected if it is stored on the machine. Store
the battery in a cool atmosphere to avoid quick
deterioration of the charge in the battery.
9. If possible, store the machine in a warm, dry location.
41