Installing And Removing The Cutting Units - Toro 04510 Greensmaster 3300 TriFlex Operator's Manual

1. Clean rod or screwdriver
2. Press down on switch
4. Release the float. The alarm should stop sounding.
5. Install the strainer screen and hydraulic tank cap. Move
the ignition switch to the Off position.
Installing and Removing the
Cutting Units
Installing the Cutting Units
1. Lift up on the foot rest and swing it open, allowing
access to the center cutting unit position (Figure 32).
CAUTION
The foot rest can pinch fingers if it falls into
the closed position.
Keep your fingers clear of the area where the
foot rest seats while it is open.
1
1. Footrest—closed
2. Position the cutting unit under the center suspension
arm.
3. With the latches on the suspension-arm bar pointing
up (i.e., open) (Figure 33), push the suspension arm
Figure 31
3. Warning buzzer
2
Figure 32
2. Footrest—open
down so that the bar fits over the bar across the top of
the cutting unit (Figure 34).
1. Latch—closed position
2. Suspension-arm bar
1
2
1. Suspension-arm bar
4. Close the latches down and around the cutting-unit bar
and lock them in place (Figure 33).
Note: A "click" can be heard and felt when the latches
are properly locked in place.
5. Coat the spline shaft of the cutting unit motor with
clean grease (Figure 35).
6. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull the
motor retaining bar on the cutting unit toward the
g014602
motor until you hear an audible "click" from both sides
of the motor (Figure 35).
27
1
2
Figure 33
3. Latch—open position
Figure 34
2. Cutting-unit bar
3
g014609
g01461 1