Blower Mode Assembly; Vacuum Mode Assembly; Operation; Tube Assembly - Black & Decker BV3100 Instruction Manual

NOTE: Ensure theblower isswitched offand disconnected from
thepower supply b efore a ttaching orremoving theblower tubes.
Thetube assembly must beassembled tothehousing before u se.
TUBE ASSEMBLY (FIGURE A)
• Toattach t hetwo piece b lower tubes t otheblower, line upthe tube
with the blower housing asshown i nfigure A.Push t he tube into the
blower housing until thelock lever e ngages thelock hole inthe tube.
• Toremove thetube depress thelock button a nd slide thetube off
thehousing neck.
VACUUM TUBE ASSEMBLY (FIGURES B, C, D)
NOTE: Ensure the vacuum is switched off and disconnected from
the power supply before attaching
or removing the vacuum tube. The
vacuum tube and collection bag must be
assembled to the housing before use.
The vacuum tubes must be assembled
together before use.
, Align the notches and the tabs on the two
tube pieces. (figure B)
, Push the lower tube firmly intothe upper
tube, until the tabs click intoplace. (Never
operate apart).
. Unlatch the fan cover from the bottom of the vacuum housin( ;Ingthe
release tab .(locatednear the front of the vacuum housinc the
cover open hke a lid (figure B1).
NOTE: This interlock will disconnect the
electric circuit automatically and the unit will
not operate. ....
. Attach the vacuum tube assembly to the
fan inlet on the vacuum housing (figure
C), insert the vacuum tube support tab
into the assembly slot (figure Cl) on the
blower housing.
. Push the lock button to lock the vacuum tube in place.
NOTE: This interlock will connect the electric circuit automatically and the unit
will operate.
COLLECTION BAG ASSEMBLY (FIGURE D}
NOTE: Ensurethe vacuum is switchedoff and--
disconnectedfrom the power supply before I0 __ ....
attachingor removingthe collectionbag. [___7_<:_. __-_ T_ _::_
. Remove blower tube ifattached. | \ _"'_.'
Push the collection bag on to the blower | ,_
housing until the lock lever engages the lock | _">_
hole as shown infigure D.
ALWAYS WEAR SAFETY GLASSES. WEAR A FILTER MASK IF
THE OPERATION IS DUSTY. USE OF RUBBER GLOVES AND
SUBSTANTIAL FOOTWEAR iS RECOMMENDED WHEN WORKING
OUTDOORS. FOR HOUSEHOLD USE ONLY.
z_WARNING: CUT HAZARD. When turning the tool off for tube
installation or any other reason, wait 10 seconds for the fan to stop
rotating before disassembly.
• Do not use in vacuum mode without the vacuum tubes and
collection bag in place.
• Always switch off and remove the plug from the electrical supply when:
• Changing from blower to vacuum.