Intended Use; Blower Mode Assembly; Vacuum Mode Assembly - Black & Decker BV2900 Instruction Manual

English
SAVE THESE INSTRUCTIONS
COMPONENTS (FIG. A)

WARNING:
tool or any part of it. Damage or personal injury
could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.

INTENDED USE

This blower vac is designed for residential applications.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
This blower vac is a residential power tool. DO nOT let
children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.

BLOWER MODE ASSEMBLY


WARNING:
off and disconnected from the power supply before
attaching or removing the blower tubes. The tube
assembly must be assembled to the housing before use.
Tube assembly
• To attach the two piece blower tubes to the blower, line
up the tube with the blower housing as shown in figure
C. Push the tube into the blower housing until the lock
lever engages the lock hole in the tube.
• To remove the tube depress the lock button and slide
the tube off the housing neck.
Figure C

VACUUM MODE ASSEMBLY

Vacuum Tube Assembly

WARNING:
switched off and disconnected from the power supply
before attaching or removing the vacuum tube. The
vacuum tube and collection bag must be assembled
to the housing before use. The vacuum tubes must be
assembled together before use.
• Align the notches and the tabs on the two tube pieces.
(figure D)
• Push the lower tube firmly into the upper tube, until the
tabs click into place. (Never operate apart).
 CAUTION:
assembly is securely seated and latched into position.
4
Never modify the power
Ensure the blower is switched
Ensure the vacuum is
CUT HAZARD. Ensure the tube
• Unlatch the fan cover from the bottom of the vacuum
housing by pressing the release tab (located near the
front of the vacuum housing) and pulling the cover
open like a lid (figure D).
Figure D
nOTE: This interlock will disconnect the electric circuit
automatically and the unit will not operate.
• Attach the vacuum tube assembly to the fan inlet on
the vacuum housing (figure E), insert the vacuum tube
support tab into the assembly slot (figure E) on the
blower housing.
• Push the lock button to lock the vacuum tube in place.
 CAUTION:
vacuum tube assembly is securely seated and latched
into position.
nOTE: This interlock will connect the electric circuit
automatically and the unit will operate.
Figure E
Collection Bag Assembly

CAUTION:
off and disconnected from the power supply before
attaching or removing the collection bag.
• Remove blower tube if attached.
• Push the collection bag on to the blower housing until
the lock lever engages the lock hole as shown in figure F.
Figure F
CUT HAZARD. `Ensure the
Ensure the vacuum is switched