InFocus IN5542 User Manual page 47

3.7.2 Communication setup
1) Using the SERIAL OUT SETTING menu, select the proper baud rate and
parity for the CONTROL OUT port, according to the specification of the RS-
232C port of the connected device. (Operating Guide - OPTION menu
- SERVICE – COMMUNICATION – SERIAL IN SETTING/SERIAL OUT
SETTING)
BAUD RATE
Data length
2) Using the COMMUNICATION TYPE menu, select the NETWORK BRIDGE
for the CONTROL OUT port. (Operating Guide - OPTION menu -
SERVICE – COMMUNICATION – COMMUNICATION TYPE)
3) Using the COMMUNICATION METHOD menu, set up the proper method
for the CONTROL OUT port, according to your use. (Operating Guide
- OPTION menu - SERVICE – COMMUNICATION – COMMUNICATION
METHOD)
• The default setting of COMMUNICATION TYPE is OFF.
NOTE
• Set up the communication using the COMMUNICATION menu.
Remember that an incorrect setup could cause communication malfunctions.
3.7.3 Communication port
For the NETWORK BRIDGE function, send the data from the computer to the
projector using the Network Bridge Port that is configured in the "Port Settings" of
web browser. (3.1.4 Port settings – Network Bridge Port)
NOTE
• Any number between 1024 and 65535 can be used as the Network
Bridge port number. By default, the number is set to 9717.
Item
4800bps/9600bps/19200bps/38400bps
PARITY NONE/ODD/EVEN
8 bit (fixed)
Start bit 1 bit (fixed)
Stop bit 1 bit (fixed)
3. Management with Web browser software
Condition
47