Fingerprint Reader Board (Select Models Only) - HP ENVY 17 Maintenance And Service Manual

Fingerprint reader board (select models only)

Description
Fingerprint reader board for use only on select HP ENVY 15 Computer Notebooks models
Fingerprint reader board for use only on select HP ENVY 17 Computer Notebooks models
Before removing the Fingerprint reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the keyboard/top cover from the base enclosure (see
7. Remove the WLAN module (see
8. Remove the subwoofer (see
9. Remove the system board (see
Remove the fingerprint reader board and cable:
1. Disconnect the ZIF connector cable (1) that secures the fingerprint reader to the keyboard/top cover.
2. Release the keyboard/top cover shield (2) and (3), and then remove the fingerprint reader board (4) by
lifting the board.
Reverse this procedure to install the fingerprint reader board and cable.
Battery on page 32),
Optical drive on page
WLAN module on page
Subwoofer on page 55).
System board on page
33).
Keyboard/top cover on page
50).
58).
Component replacement procedures
Spare part number
763789-001
763711-001
36).
71