Touchpad Button Board - HP ENVY 17 Maintenance And Service Manual

TouchPad button board

Description
TouchPad button board (includes cable) for use on HP ENVY 15 Notebook PC computer models
TouchPad button board (includes cable) for use on HP ENVY 17 Notebook PC computer models
Before removing the TouchPad button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the keyboard/top cover from the base enclosure (see
Remove the TouchPad button board:
1. Turn the top cover upside down, with the front toward you.
2. Remove the two broadhead screws (1) that secure the TouchPad button board bracket to the
keyboard/top cover.
NOTE:
3. Remove the TouchPad board by carefully pushing the TouchPad down (2) and routing the cable through
the opening (3) (the cable was disconnected earlier from the keyboard/top cover).
Reverse this procedure to install the TouchPad button board.
52 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
Optical drive on page
Some models may have three broadhead screws for the TouchPad button board (1).
32).
33).
Keyboard/top cover on page
Spare part number
763790-001
763712-001
36).