Horizon Fitness LS 925T User Manual page 5

P R E- ASSE MBLY
Disassemble box and remove the cardboard packaging that is not beneath the treadmill. Do not attempt to
lift the treadmill at this time. Remove plastic wrap from console masts.
NOTE:
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
AS SE MB LY ST EP 1
HARDWARE BAG 1 CONTENTS :
LEAD WIRE
CONSOLE MAST
FLAT WASHER
BOLT (A)
SPRING WASHER
MAIN FRAME

LS_925T_Treadmill_Rev.2.1.indd 8-9
FLAT WASHER (B)
BOLT (A) SPRING WASHER (C)
16 mm
65 mm 16 mm
Qty: 4
Qty: 4 Qty: 4
CONSOLE CABLE
A Open HARDWARE BAG 1.
B Pull LEAD WIRE through RIGHT CONSOLE
MAST to drag upward.
C Place LEFT CONSOLE MAST into upright
position. Be sure to hold the console mast
firmly, as it will not stay in the upright
position on its own.
D Use BOLTS (A), 2 SPRING WASHERS (C),
and 2 FLAT WASHERS (B) to attach console
mast to the MAIN FRAME.
E Repeat on the right side.
ASSEMBLY STEP 2
HARDWARE BAG 2 CONTENTS :
BOLT (D) FLAT WASHER (E)
20 mm
16 mm Diameter
Qty: 4
Qty: 4
top view
1
3
2
WASHERS (E)
BOLT (D)
* Be sure to tighten bolts after all are lined up.
ASSEMBLED IN STEP 2-C
* NOTE: Be careful not to pinch any
wires while assembling the masts.
Open HARDWARE BAG 2.
A
Lift the RUNNING DECK until lock
B
latch on side of treadmill is fully
engaged (See step 1).
Remove CONSOLE from box
C
and place out of the way
(See step 2).
D Lower the treadmill RUNNING
DECK from the folded position
by stepping on LOCK LATCH on
lower left side (See step 3).
E
With running deck in lowered
position, place CONSOLE on
upright masts.
F Place FLAT WASHER (E) and
BOLT (D) into LEFT upright
MAST and CONSOLE and
lightly tighten.
G Gently lift RIGHT side of the
console to connect the CONSOLE
CABLE. Carefully tuck wires in
mast to avoid damage. Note: Do
not pinch console cable. Be sure
the console cable prongs are
aligned and the ends are tightly
seated into each other.
H Repeat steps F-G above to
assemble the right side upright
mast and console.
I Tighten all bolts completely.
9
1/15/07 10:51:17 AM