Beam ISATDOCK PRO User Manual page 18

3) Privacy Handset & Mounting Cup
The Privacy Handset is conveniently mounted
on to the IsatDock PRO enclosure, providing a
local handset function.
The Privacy Handset connects to the docking
station via a RJ9 connector. The privacy handset
is connected beneath the rear panel of the
IsatDock. Once connected, the cable is run back
through the foam and placed in the 'S' channel
through the base of the phone.
RJ9 connection
See section 4 on page 19
Changing Cups
1. Unhook the privacy handset from cup.
2. Remove cup cover to expose screws.
3. Unscrew 3 screws with a phillips screwdriver.
4. Detach the cup and replace with the
spring or springless cup.
18
1
2
3
4
There are two options for the privacy
handset mounting cup depending upon the
environment or condition where the docking
unit is mounted. (1) springless cup for stationary
use vertical or horizontal position. (2) spring cup
for rough conditions.
(1) Springless Cup for Normal light-use
Desk mounted cradle position.
The 'springless' cup is fitted to the docking station
with the mounting clip in a 'flush' position.
Wall mounted cradle position.
The mounting clip can be slid out and
reversed, producing a protruding point that
the Privacy handset rests upon. For a wall
mounted docking station this retains the
privacy handset and the springless cup has
enough height to allow the handset to rise
up off the clip and out of the mounting cup