Beam ISATDOCK PRO User Manual page 17

a
Fit the docks feet in the large holes of the bracket
b c
Slide the dock down
Once the dock as been locked onto the mount-
ing bracket on the wall, two security bolts are
then slid into place locking the dock to the wall.
Security Bolts
Two security bolts ensure the PRO docking unit
is firmly fixed to the wall and only removed by an
'authorized' (the security key holder) personnel.
Once the IsatDock PRO is fitted to the wall,
these two security bolts prevent the docking
station from sliding back up freeing the dock.
The security bolts are 4mm in diameter and have a
slot for a flat blade screwdriver.
The bolt under the privacy handset mounting
cup must be fitted prior to the cup being screwed
into place. The second bolt is placed under
the IsatPhone Pro in the recess for the handset
antenna cover. Both bolts are then covered with
plugs. As the second bolt is under the IsatPhone
Pro, access to the bolt is denied when the handset
is locked into the cradle.
Final lock position
IsatDock PRO - Installation & User Manual
2b) Desk Mounting Orientation
The IsatDock PRO supports a desk mount
configuration. Depending on the users
requirements the docking station supports both
a flat and raised orientation on the desk.
To configure the IsatDock for a desk installation:
1. Fit the mounting bracket to the back of
the IsatDock as shown in section (2a) wall
mounting directions.
2. Flip the feet out if required and locate the
IsatDock on the desk.
When desk mounting, the security bolts are not
required to be fitted.
17