Beam ISATDOCK PRO User Manual page 16

ISD700
Directional/Fixed Antenna
(Passive) with Bracket
Transport Antenna
(Active)
NOTE
Refer to the section "Antenna Installation" for more
information on antenna placement and installation.
Only Beam approved antenna cables should be used
with all docking stations and antennas.
16
WARNING
DO NOT pull with force on the cables from the
rear of the IsatDock PRO. Please install strain relief
clamping for the antenna cables where required.
Correct installation of the antenna system is a vital
part of the IsatDock PRO system, to ensure reliable
functionality, and drop-free calls.
WARNING
Changes or modifications not expressly approved
ISD715
Magnetic
by Beam Communications could void the user's
Mounting
authority to operate the equipment.
ISD720
WARNING
Bolt
To satisfy FCC RF exposure requirements for mobile
Mounting
transmitting devices, a separation distance of
55cm or more should be maintained between the
antenna of this device and persons during device
operation. To ensure compliance, operations at
closer than this distance is not recommended.
2a) Wall Mounting Orientation
There are nine screw holes available for mounting
the bracket to a wall. It is recommended that
a minimum of 2 screws are used to ensure the
docking station is mounted securely.
There are four keyhole shaped slots in the
mounting bracket that mate with feet on the
rear of the docking station. To attach the
bracket, the larger end of the keyhole will pass
over the feet. The bracket is then slid up to lock
the feet into the narrow section of the keyhole.