Installation Safety - Samsung NY58J9850WS User Manual

• Do not put a fuse in a neutral or ground circuit.
• If the power cord is damaged, it must be replaced by the manufacturer, its
service agent, or similarly qualified persons to avoid creating a hazard.
• Do not connect the ground wire to plastic plumbing lines, gas lines, or hot
water pipes.
• This range must be Earth grounded. In the event of a malfunction or
breakdown, grounding will reduce the risk of electrical shock by providing
a path for the electric current. This range is equipped with a cord having
a grounding plug. The plug must be firmly plugged into an outlet that is
properly installed and grounded in accordance with the local codes and
ordinances. If you are unsure whether your electrical outlet is properly
grounded, have it checked by a licensed electrician.
• Ensure that the appliance is switched off before replacing the lamp to avoid
the possibility of electric shock.
• The range should not be placed on a base.
• Electrical service to the range must conform to local codes. Barring local
codes, it should meet the latest ANSI/NFPA No. 70 – Latest Revision (for the
U.S.) or the Canadian Electrical Code CSA C22.1 – Latest Revisions.
• It is the personal responsibility of the range owner to provide the correct
electrical service for this range.

INSTALLATION SAFETY

WARNING
To reduce the risk of fire, electric shock, personal injuries, and/or death, observe
the following precautions.
• Have your range installed and properly grounded
by a qualified installer, in accordance with the
installation instructions. Any adjustment and service
should be performed only by qualified gas range
installers or service technicians.
• Do not attempt to service, modify, or replace your range or any part of your
range unless it is specifically recommended in this manual. All other service
should be referred to a qualified technician.
• Always use new flexible connectors when installing a gas appliance. Do not
use old flexible connectors.
• Make sure the anti-tip device is properly installed on the range. See the
installation instructions for more information.
• This range is very heavy. During installation, always have two or more people
move the range.
• Remove all tape and packaging materials. These materials can ignite, causing
smoke and/or fire damage.
• Remove all accessories from the cooktop, oven, and/or lower drawer. Grates
and griddles are heavy. Use caution when handling them.
• Make sure no parts came loose during shipping. Do not install in an area
exposed to dripping water or outside weather conditions.
• Make sure your range is correctly installed and adjusted by a qualified service
technician or installer for the type of gas (natural or LP) you will use. For
your range to utilize LP gas, the installer must replace the 5 surface burner
orifices and 2 oven orifices with the provided LP orifice set, and reverse
the GPR adapter. These adjustments must be made by a qualified service
technician in accordance with the manufacturer's instructions and all codes
and requirements of the authority having jurisdiction. The qualified agency
performing this work assumes the gas conversion responsibility.
• Installation of this range must conform with local codes or, in the absence of
local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest
edition. In Canada, installation must conform with the current Natural Gas
Installation Code, CAN/CGA-B149.1, or the current Propane Installation Code,
CAN/CGA-B149.2, and with local codes where applicable. This range has been
design-certified by ETL according to ANSI Z21.1, latest edition, and Canadian
Gas Association according to CAN/CGA-1.1, latest edition.
English 7