Replacing The Mower-Deck Belts For 102 Cm Mowers; Replacing The Right Mower-Deck Belt; Replacing The Left Mower-Deck Belt - Toro 74534TE GrandStand Operator's Manual

1. Belt
2. Spring-loaded idler pulley
Replacing the Mower-deck
Belts for 102 cm Mowers
Important: The fasteners on the covers of this machine
are designed to remain on the cover after removal.
Loosen all of the fasteners on each cover a few turns so
that the cover is loose but still attached, then go back
and loosen them until the cover comes free. This will
prevent you from accidentally stripping the bolts free
of the retainers.
Replacing the Right
Mower-deck Belt
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Loosen the bolts and remove the belt covers with the
bolts attached to them.
4. Remove the spring from the anchor post on the
idler-pulley arm (Figure 64).
5. Remove the worn mower belt (Figure 64).
6. Install the new mower belt around the deck pulleys and
idler pulley (Figure 64 ).
7. Install the spring onto the anchor post on the
idler-pulley arm (Figure 64 ).
8. Install the belt covers onto the cutting unit and secure
the bolts.
Figure 64
3. Spring
1. Belt
2. Spring
Replacing the Left Mower-deck
Belt
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Loosen the bolts and remove the belt covers with the
bolts attached to them.
4. To remove the left mower belt, the right mower belt
needs to be removed first; refer to Replacing the Right
Mower-deck Belt (page 47).
5. Remove the spring from the anchor post on the
idler-pulley arm (Figure 64).
6. Remove the worn mower belt (Figure 64).
7. Install the new mower belt around the deck pulleys, the
clutch pulley, and the idler pulley (Figure 64).
8. Install the spring onto the anchor post (Figure 64).
9. Install the right mower belt; refer to Replacing the
Right Mower-deck Belt (page 47).
10. Install the belt covers onto the cutting unit and secure
the bolts.
47
Figure 65
3. Spring-loaded idler pulley