Controls System Maintenance; Adjusting The Motion-Control-Handle Positions - Toro 74534TE GrandStand Operator's Manual

Controls System
Maintenance
Adjusting the
Motion-control-handle
Positions
Adjusting the Right Side Motion-control
Lever
If the motion-control levers do not align horizontally, adjust
the right side motion-control lever.
Note: Adjust the horizontal alignment before the front to
back alignment.
1. Disengage the PTO, move the right side motion-control
lever to the neutral position, and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Push the right motion-control lever down out of the
neutral-locked position (Figure 68).
4. Check if the right motion-control lever aligns
horizontally with the left motion-control lever (Figure
68).
Figure 68
1. Left motion-control lever
2. Right motion-control lever
in the neutral-locked
position
5. To adjust the right motion-control lever horizontally,
the cam needs to be adjusted.
6. Release the cushion from the rear of the machine.
7. Loosen the nut holding the cam (Figure 69).
3. Check the horizontal
alignment here
4. Right motion-control lever
1. Cam
8. Adjust the cam until it aligns with the left
motion-control lever and tighten the nut for the cam.
Note: Moving the cam clockwise (in the vertical
position) lowers the handle, while moving it
counterclockwise (in the vertical position) raises the
handle.
Important: Ensure that the flat portion of the
cam does not go above a vertical position (right or
left), or you may cause damage to the switch.
49
Figure 69
2. Nut