Servicing The Fuses; Drive System Maintenance; Adjusting The Tracking - Toro 74534TE GrandStand Operator's Manual

6. Install the battery onto the machine and connect the
battery cables; refer to Installing the Battery (page 40).
Note: Do not run the machine with the battery
disconnected; electrical damage may occur.
Figure 53
1. Positive Battery Post
2. Negative Battery Post

Servicing the Fuses

The electrical system is protected by fuses. It requires no
maintenance. If a fuse blows, check the component or circuit
for a malfunction or short.
1. Release the operator cushion from the rear of the
machine.
2. Pull out on the fuse to remove and replace it (Figure
54).
3. Install the operator cushion.
Figure 54
1. Controls
2. Wire
3. Red (+) Charger Lead
4. Black (-) Charger Lead
g013015
3. Fuses
Drive System
Maintenance

Adjusting the Tracking

Note: Determine the left and right sides of the machine
from the normal operating position.
1. Push both control levers forward the same distance.
2. Check if the machine pulls to one side.
Note: If it does, stop the machine and set the parking
brake.
3. Release the cushion from the rear of the machine.
4. Rotate the right cable adjustment to position the right
motion control in the center of the control panel
neutral-lock slot (Figure 56).
1. Left motion-control lever
2. Right motion-control lever
5. Rotate the left cable adjustment to match the left
wheel speed to the previously set right wheel speed.
6. Adjust in quarter-turn increments until the machine
tracks straight.
Note: Only adjust the left cable to match the left
wheel speed to the right wheel speed. Do not adjust
the right wheel speed as this will position the right
motion-control lever out of the center for the control
panel neutral-lock slot.
41
g015241
Figure 55
3. Neutral-locked position
4. Align the control levers
front to back