Operating The Choke; Operating The Ignition Switch - Toro 74534TE GrandStand Operator's Manual

Operating the Choke

Use the choke to start a cold engine.
1. If the engine is cold, use the choke to start the engine.
2. Pull up on the choke knob to engage the choke before
using the ignition switch (Figure 14).
3. Push down on the choke to disengage the choke after
the engine has started (Figure 14).
1
2
1. On position
G008959
Figure 14
2. Off position

Operating the Ignition Switch

1. Turn the ignition key to the Start position (Figure 15).
Note: When the engines starts, release the key.
Important: Do not engage starter for more than 5
seconds at a time. If the engine fails to start allow
a 15 second cool-down period between attempts.
Failure to follow these instructions can burn out
the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
2. Turn the ignition key to the stop position to stop the
engine.
19
G008947
Figure 15