Mobile Home Installation: Us Only - SCAN A10 Instructions For Installation And Use Manual

Mobile Home Installation: US only

In addition to standard installation the following requirements are mandatory for installation in a
mobile home.
The stove must be permanently bolted to the floor of the mobile home using the floor screws
provided.
Note: If the composition of the manufactured (mobile) home floor is of light particleboard
construction, you will be required to secure the stove with regular hex head bolts and nuts. This will
ensure that the bolts will not rip out of the floor when the manufactured (mobile) home is being
moved.
The stove must have permanent outside air source for combustion. See Outside Air Requirements
The stove must be electrically grounded to the steel chassis of the mobile home.
A listed chimney system, roof thimble, spark arrestor and roof flashing kit suitable for use in mobile
homes must be used.
The chimney shall be attached directly to the room heater and shall extend at least 3ft. above the
part of the roof through which it passes. The top of the chimney should project at least 2 ft. above
the highest elevation of any part of the mobile home within 10 ft. of the chimney.
The chimney system shall comply with Local Requirements.
Check local building code as other local codes may apply.
CAUTION: THE STRUCTURAL INTEGRITY OF THE MOBILE HOME ROOF, FLOOR, WALLS
AND CEILING MUST BE MAINTAINED.
WARNING: DO NOT INSTALL IN A SLEEPING ROOM OF A MOBILE HOME.
CAUTION: Do not obstruct combustion air opening air opening when the stove is in use.
Note: Listed factory built chimney connectors including elbows are acceptable for use in mobile
home installations.
10