Table Of Contents - Toro 38597 Operator's Manual

2
Installing the Wheel Clutch
Cable Ends
No Parts Required
Procedure
Models 38633, 38637, and 38657 only
1. Unwrap the cable ends from the lower handle
(Figure 5).
2. Route either the left or right cable end over the lower
handle and insert the cable end into the hole in the
corresponding wheel clutch lever (Figure 6).
Figure 4
Figure 5
1. Wheel clutch lever
3. Remove the nut and washer from the handle, attach
the cable clamp on the cable to the handle, install
the washer and the nut, and hand tighten the nut
(Figure 7).
1. Cable clamp (2)
Important: Ensure that the curved side of the
cable clamp is against the handle and that the
cable is routed below the clamp bolt. The cable
must be in a straight line from the cable clamp
to the point where it attaches to the wheel clutch
lever.
4. Pull the cable jacket down gently until the wheel
clutch lever is down and the slack is out of the cable,
then tighten the cable clamp nut securely (Figure 8).
5. Squeeze the lever fully, then check the gap between
the bottom of the handle and the wheel clutch lever
end (Figure 9).
8
Figure 6
Figure 7
Figure 8