Table of Contents
Advertisement
Maintenance
1. Winglet stabilizer brackets
3.
Start the engine and raise the front deck completely,
then stop the engine.
4.
Move the stabilizer brackets inward until the rollers
contact the skirt of the machine, then tighten the
capscrews locking adjustment.
TRACTION CONTROL NEUTRAL
ADJUSTMENT
If the machine moves when the traction pedal and pump
lever are in the neutral position, adjustment is required.
1.
Park the machine on a level surface, engage the
parking brake, raise the wing decks completely,
lower the front deck to the ground and turn the
engine OFF
2.
Actuate the pump lever (with the foot pedal) to
make sure that the foot pedal and linkage operate
freely. Correct if necessary.
3.
Put blocks at the front and rear of all four wheels.
Disengage the two (2) planetary wheel drives; refer
to Pushing or Towing Machine.
Failure to put the machine on a level surface, block
the wheels and disengage the planetary wheel drives
before doing neutral adjustment procedure could
result in personal injury from machine movement.
4.
With the engine OFF, loosen the nut on the carriage
bolt and allow the bearing to locate the cam
(Fig. 70). Carefully tighten the nut on the carriage
bolt.
46
Figure 69
1. Screws
2. Neutral device bracket
3. Cam
4. Neutral switch
5. Carriage bolt
6. Bearing
5.
Loosen the screws to allow the neutral device
bracket to move; but not freely (Fig. 70). Adjust the
neutral device bracket so that 40± in-lb of torque on
the control lever just starts to rotate the lever.
Tighten the screws.
6.
Adjust the neutral switch; refer to Traction (Neutral)
Switch Replacement and Adjustment.
7.
Adjust the traction control rod; refer to Traction
Control Rod Adjustment.
8.
If movement is still evident when the traction pedal
and pump lever are in neutral, contact your local
authorized TORO Distributor for assistance.
TRACTION (NEUTRAL) SWITCH
ADJUSTMENT
1.
Make sure the traction pedal is in the neutral
position. Loosen the jam nut on the switch adjusting
screw (Fig. 71).
2.
Rotate the adjusting screw toward the switch until a
circuit through the switch is made.
3.
Rotate the adjusting screw an additional 1 turn.
Tighten the jam nut.
Figure 70
Hide quick links:
Advertisement
Table of Contents
