Controls - Toro GROUNDSMASTER 580-D 30581 Operator's Manual

Controls

Seat (Fig. 12)—Pull the seat adjusting lever (right side)
outward, slide the seat fore or aft to the desired position and
release the lever to lock the seat in position. The seat moves
15 cm fore and aft in 15mm increments. The knob at the
lower center provides variable weight adjustment from
49.9–129.3 kg.
1. Seat adjusting lever
2. Weight adjusting knob
3. Weight indicator
Seat height adjusts vertically to three positions. To raise: lift
the seat to the first or second click stop; to lower: lift the
seat to the highest position, then lower it to the lowest
position. The arm rests pivot up and down.
Warning Light Check Switch (Fig. 13)—Before
beginning operation, press the switch button. All lights on
the control panel should light. If a light fails to illuminate,
there is an electrical malfunction requiring immediate
repair.
Engine Oil Pressure Warning (Fig. 13)—Dangerously
low engine oil pressure is indicated by both a warning
indicator light and an audible signal. When this occurs, stop
the engine immediately avoid engine damage.
No Charge Warning (Fig. 13)—No charge to the batteries
is indicated by a warning indicator light and audible signal.
Fuel System Warning (Fig. 13)—A warning indicator light
and audible signal warn of water in the fuel and need for
service.
Coolant Temperature Warning (Fig. 13)—If engine
coolant temperature exceeds 101° C, a warning indicator
light illuminates and an audible signal sounds. If coolant
temperature exceeds 110° C, the engine automatically shuts
down. The switch resets automatically when the system and
engine cool down.
16
Figure 12
Hour Meter (Fig. 13)—Registers accumulated hours of
engine operation, which is useful for determining intervals
for service maintenance and lubrication.
Coolant Temperature Gauge (Fig. 13)—Indicates the
temperature of system coolant.
Fuel Gauge (Fig. 13)—Indicates the quantity of fuel in the
fuel tank.
1. Coolant temperature gauge
2. Fuel gauge
3. Hour meter
4. Coolant temperature warning
5. Engine oil pressure warning
6. No charge warning
7. Fuel system warning
8. Warning light check switch
Hydraulic Oil Temperature Warning (Fig. 14)—A
warning indicator light and audible signal warn of
excessively high hydraulic oil temperature.
1. Hydraulic oil level warning
2. Hydraulic oil temperature warning
3. Hydraulic oil filter warning
4. Air cleaner warning
5. Alarm silence button
Figure 13
Figure 14