Maintenance Schedule - Toro GROUNDSMASTER 580-D 30581 Operator's Manual

Maintenance
Maintenance Procedure
Lubricate All Grease Fittings
Inspect Air Filter, Dust Cup, and Baffle
Clean Under Cutting Unit Belt Covers
Check Cutting Unit Drive Belt
Adjustment
‡Change Engine Oil and Replace Filter
Check Fan and Alternator Belt Tension
Inspect Cooling System Hoses
Service Air Filter
Replace Fuel/Water Separator Filter
Torque Wheel Lug Nuts
Check Battery Level/Cable Connections
‡Replace Hydraulic Filter
‡Torque Head and Adjust Valves
‡Check Engine RPM (idle and full throttle)
‡Change Planetary Gear Drive Fluid
Check Rear Wheel Toe In
Initial break in at 10 hours
‡Initial break in at 50 hours
Change Brake Fluid
Change Fuel Filter
Change Thermostat
Replace Safety Switches
Flush Cooling System and Replace Hoses
Fuel Tank- Drain/Flush
Change Hydraulic Oil
30

Maintenance Schedule

Every
50
hours
Maintenance Interval & Service
Every Every
100 200
hours hours
Recommendations
Items are recommended every 1000 hours
or 2 years, whichever occurs first.
Every Every
400 800
hours hours