Checking And Adjusting The Auger/Impeller Cable - Toro Power Max 828LXE 38631 Operator's Manual

1.5 mm) from the front of the slot to the front edge of the
pin (Figure 44).
Figure 44
1. Pin
2. 1/32 to 1/16 inch (1 to 1.5 mm)
If the left hand (traction) cable is not properly adjusted,
do the following steps:
1. Loosen the jam nut.
2. Loosen or tighten the turnbuckle to adjust the pin until
it is the proper gap from the front edge of the slot.
3. Tighten the jam nut (Figure 45).
Figure 45
1. Jam nut
Checking and Adjusting the
Auger/Impeller Cable
Check and adjust the auger/impeller cable after the first
2 operating hours, then yearly thereafter.
1. Remove the 2 screws from the right side of the belt
cover as shown.
2. Lift up the right side of the belt cover (Figure 46).
2. Turnbuckle
Figure 46
3. With the auger/impeller lever disengaged, ensure that
the gap between the auger clutch assembly and the tab
is 1/16 inch (1.5 mm) (Figure 47).
Figure 47
1. Tab
2. 1/16 inch (1.5 mm)
4. If the auger/impeller cable is not properly adjusted, do
the following steps:
5. Loosen the jam nut (Figure 48).
Figure 48
1. Jam nut
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable (Figure 48).
18
2. Turnbuckle