Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
1.
2.
3.
4.
5.
6.
7.
8.
1. Installing the Upper Handle
Note: Do not remove the rubber band until you have
installed the upper handle.
1. Lift and rotate the upper handle and position it over
the lower handle (Figure 3).
Important: Route the cables attached to the
Quick Stick inside the upper handle legs and
ensure that the cables and the wire for the headlight
are not pinched between the handle sections.
Description
Handle bolts
Curved washers
Locknuts
No parts required
No parts required
Carriage bolts
Locknuts
Cable ties
No parts required
No parts required
No parts required
Qty.
4
4
Install the upper handle.
4
–
Install the wheel clutch cable ends
–
Install the traction control linkage.
2
Install the chute control rod.
2
2
Connect the wire to the headlight.
–
Fill the engine with oil.
–
Check the tire pressure.
–
Check the skids and scraper.
Figure 3
1. Cables
2. Secure the upper handle with 4 handle bolts, 4 curved
washers, and 4 locknuts from the loose parts bag (Figure
4).
6
Use