Replacing The Drive Belts; Replacing The Headlight Bulb - Toro Power Max 828LXE 38631 Operator's Manual

Replacing the Drive Belts

If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, go to
www.Toro.com for additional service information or have
an Authorized Service Dealer replace the belt.

Replacing the Headlight Bulb

Use a GE 892 16W halogen light bulb. Do not touch the
bulb with your hands or allow dirt or moisture to come into
contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 57).
Figure 57
2. Turn the base of the bulb counterclockwise until it
stops (Figure 58).
Figure 58
3. Remove the bulb straight out from the back of the
headlight (Figure 59).
Figure 59
4. Insert a new bulb into the back of the headlight (Figure
60).
Figure 60
5. Turn the base of the bulb clockwise until it is snug
(Figure 61).
Figure 61
6. Insert the wire connector straight into the back of the
headlight until it is securely in place (Figure 62).
Figure 62
21