Send Tag Id (Alien Only); Send Tag Id With Verify (Alien Only) - Datamax-ONeil I-Class User Manual

STX KuT

Send Tag ID (Alien only)

This command instructs the RFID device to read data from the tag and return it to the host. This is
a low level command that issues an air interface command to acquire one tag ID. There is no
collision avoidance used. A CRC validation is performed on the data; however, the CRC data is
not returned.
Syntax: <STX>KuT<CR>
Printer response: Parameter 0 – Tag Decode Status:
Parameter 1 – Antenna Number: 0x00 (always)
Parameter 2 – Tag Data Length (only included if 'Good' ID status):
Parameter 3 thru (Tag Data Length + 2), (only included if 'Good' ID status):
STX KuV

Send Tag ID with Verify (Alien only)

This command instructs the RFID device to send a VERIFY air interface command. Data is
reported regardless of CRC verification.
<STX>KuG<CR>
Syntax:
Printer response: Parameter 0 – Tag Decode Status:
Parameter 1 – Antenna Number: 0x00 (always)
Parameter 2 – Tag Data Length, with CRC and kill/lock codes (only
included if 'Good' ID status):
Parameter 3: CRC byte one
Parameter 4: CRC byte two
Parameter 5 thru (Tag Data Length): Tag Data, MSB to LSB
Param Tag Data Length + 1: Kill Code
Param Tag Data Length + 2: Lock Code
= Good ID
0x00
= No Tag
0x01
= Collision
0x02
0x03 = CRC Error
= 64-Bit Tag
0x08
0x0C = 96-Bit Tag
Tag Data, MSB to LSB.
= Good ID
0x00
= No Tag
0x01
= Collision
0x02
0x03 = CRC Error
= 64-Bit Tag
0x0C
0x10 = 96-Bit Tag
15