Samsung NV70F77 Series User Manual page 7

installation
Safety instructions for the installation
This oven may be installed only by an approved electrician. The installer is responsible for
connecting the appliance to the main supply, while observing the relevant safety regulations.
• Ensure protection from live parts when installing the oven.
Power connection
If the appliance is not connected to the mains with a plug, a multi-pole isolator switch (with at least 3 mm contact
spacing) must be provided in order to satisfy safety regulations. The power
cable (H05 RR-F or H05 VV-F, min., 2.5 mm²) must be of sufficient length to be
connected to the oven, even if the oven stands on the floor in front of its built-in
cabinet. Open the rear connection cover of the oven with a screwdriver and
loosen the screws of the cable clamp before you connect the power lines to the
relevant connection terminals. The oven is earthed via the (
yellow and green cable(earth connection) must be connected first and be longer
than the others. If the oven is connected to the mains with a plug, this plug must
remain accessible after the oven is installed. Samsung will take no responsibility
for accidents that originate from a missing or faulty earth connection.
WARNING: Do not allow the connecting cable to become trapped during installation, and
prevent it coming into contact with hot parts of the oven.
installation in the cabinet
With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside of
the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage of plastic
surfaces or adhesive from the heat.
There should be a ventilation gap in the base of the kitchen cabinet where the oven is to be placed. For
ventilation, a gap of about 50mm should be left between the lower shelf and the supporting wall. If the
oven is to be installed below a hob, the hob's installation instructions should be followed.
370
Max.50
595
595
21
Built-in
Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws. Make
sure that a gap of at least 5mm should be left between the appliance and the adjacent cabinet.
After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside
of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and
release the 2 screws on the both sides of the oven.
WARNING: The built-in furniture must have a minimum ventilation gap for Air-flow as shown
on picture. Do not cover this hole with strips of wood, for this is used to provide ventilation.
The front exterior of the oven such as handle is different model by model. But the size of the
oven in the picture is same.
NV70F7786HS-EU_DG68-00522A _EN.indd 7
Min.550
Min.560
Min.50
560
Min.590 ~ Max.600
5 5 0
5 50
7 5 5 72 2
545
Min.460 x Min.50
)-terminal. The
Min.550
175
370
85
595
5 5 02 0 2
595
490
21
ENGLISH - 7
BROWN BLUE or YELLOW
or BLACK WHITE and GREEN
Min.560
560
Min.600
5 5 0
5 50
7 5 2
5 72
Min.460 x Min.50
545
Built-under
Built-in + Built-under
2014-03-05
0
6:59:19