Table of Contents
Advertisement
COBAL T
BOW TONNEAU COVER -
OPTIONAL
Follow these procedures to attach the bow tonneau
cover:
1. Open walk-thru doors.
2. Starting at bow, slip bow opening over bow,
work aft, and snap the cover to the boat.
3. Close windshield center door and snap the
canvas to the underside of the windshield.
4. Install the adjustable tonneau cover support
pole. Make sure the pole is perpendicular to the
floor and adjust to "tent" the cover.
5. Walk-thru doors may be closed if desired.
Do not use bow tonneau cover for extended
storage. It is not designed for storage, but can be
used for overnight storage or trailering.
NOTICE: Always double-check
snaps are secure.
COCKPIT TONNEAU COVER -
OPTIONAL
Follow these directions for the cockpit tonneau
cover.
1. Unroll the cover and snap to the deck, starting
at the center of the windshield. Snap to the
forward outside edge of the windshield only.
2. Install tonneau support pole(s) to underside of
the cover (just in front of rear seat) with snap
and adjust pole to approximate height of
windshield. Some models have two support
poles. Make sure the poles are perpendicular to
the floor and adjust to "tent" the cover.
3. Pull elastic cords over discs on transom,
starting in the center and working outboard (you
may have to readjust the support poles for
proper fit).
4. Continue snapping up the sides.
5. The walk-thru doors may be closed if desired.
24SD
SPORT DECK
3
-
Do not use cockpit tonneau cover for extended
storage. It is not designed for storage, but can be
used for overnight storage or trailering.
NOTICE: Always double-check
snaps are secure.
BOW TONNEAU
(BOW RIDERS ONLY)
SS ARCH WITH BIMINI
INSTRUCTIONS - OPTIONAL
To set up bimini from the stored position:
1. Unzip the canvas boot from the bimini and arch.
2. Zip the aft edge of the bimini to the forward
tubing of the arch.
3. Install two forward support bars and tighten the
bimini by twisting the tensioners.
A
To avoid injury or death, do not use the
arch for towing or as a support. It is not
designed to hold the additional weight.
CAUTION
The arch with bimini is designed for
Cobalt factory-installed equipment only.
Do not add any additional equipment
without authorization from Cobalt.
38
S
ECTION
COCKPIT
TONNEAU
COB_0138_A
DANGER
24SD Owner's Manual
3
Advertisement
Table of Contents
