Table of Contents
Advertisement
COBAL T
VacuFlush Head
A
CAUTION
Avoid damage to the waste system. Do
not flush into a full holding tank.
1. Make sure the water pump is on.
2. Turn on the VacuFlush rocker switch, located on
the panel. A red light will turn green when the
system is ready.
3. To charge the head, raise the foot pedal on the
lower left side of the bowl.
4. To flush, depress the foot pedal.
Your boat is fitted with a waste holding tank. It is
emptied through the deck plate fitting marked
"WASTE". Waste is pumped from the head through
a sanitary waste hose to the top portion of the tank.
A sanitary waste hose is attached to the bottom of
the tank, and runs to the dockside pump-out plate.
An overboard vent keeps the tank at atmospheric
pressure regardless of waste levels.
The optional macerator system allows the
discharging of waste water from the waste tank
directly overboard. For additional operating
information, refer to the macerator operator's
manual.
NOTICE: Overboard discharge
of waste water should only be
used in approved areas. It is
your responsibility to comply
with local regulations regarding
the discharge of waste. You
could be fined if your boat has
an operable overboard
discharge system.
To avoid a fine, remove the
handle of the seacock (in the
CLOSED position) or disable
the system by other means such
as locking the "Y" valve in the
"pump-out" position.
24SD
SPORT DECK
3
-
All the components of the waste system are made
of materials specially formulated to prevent odor
permeation. It is strongly recommended you
regularly add chemical to your tank by flushing it
through the head. The chemical helps to control
odor and break down the waste. Follow the
manufacturer's instructions on the chemical before
using.
A waste tank level monitor is installed to provide a
visual indication of the amount of waste in the tank.
The ignition key may need to be on for the monitor
or water pump to work.
Dockside Waste Disposal
1
1 – Water Tank
2 – Head
3 – Waste Dockside Pump-out Fitting
4 – Vent
5 – Holding Tank
Dockside Pump-out - This system directs all
waste to the holding tank. To clear the tank, you will
need to use the dockside pump-out services
provided at marinas or other facilities. To empty the
tank, a suction hose is connected to the "WASTE"
pump-out plate and to the dockside pump. The
WASTE pump-out plate is always located at a "high
point" on the boat. For the WASTE pump-out
connection, refer to Section 4, Water/Plumbing.
36
S
ECTION
3
2
4
5
COB_0190_C
24SD Owner's Manual
3
Advertisement
Table of Contents
