Table of Contents
Advertisement
COBAL T
CAPTAIN'S CHAIR
ADJUSTMENTS AND
OPERATION
Your captain's chairs have the flip-up position for
greater visibility and maneuverability while docking.
You can sit on the raised cushion or stand in front of
the cushion.
Standing while driving your boat should only be
done while maneuvering at an idle by an
experienced driver.
The chairs are adjustable fore and aft and also
rotate. Some fore and aft adjustment may be
necessary when swiveling your seat(s) to avoid
damage to the chair or side panel. Some seating
configurations do not allow all seats to rotate
completely.
3
1. Lift lever to adjust fore and aft.
2. Turn rotation friction handle clockwise to
increase friction and counterclockwise to
decrease friction. The chair should always be
operated with slight friction.
3. Rotation lever for chair - move chair slightly
forward, then lift lever to rotate. The lever will
rest in its detent when the seat is in its forward
direction.
A
DANGER
Avoid potential injury or ejection of
occupants. DO NOT stand while driving
above engine idle speeds and make sure
all passengers are seated and seats are
in a locked/secured position when the
boat is underway.
24SD
SPORT DECK
1
2
COB_0093_A
3
FLIP DOWN SWIM STEP
Boat in the Water
First, lower the drive all the way.
To deploy the step:
1. Kneel down to reach the plunger; pull the
plunger out and pull up on the step at the same
time.
2. Push the step over into the water. The step will
be buoyant.
3. Sit on the platform and push the step down with
your feet; it will automatically lock into place.
To raise the step:
1. Push down slightly on the step with your feet
while sitting on the platform.
2. Pull the plunger and allow the step to float up.
3. Move to the side and pull the step onto the
platform. It will automatically lock into place.
Boat on a Trailer
Lower the drive as low as possible without hitting
the ground or trailer.
To deploy the step:
1. Stand behind the platform; pull the plunger out
and pull up on the step at the same time.
2. Pull the step towards you; do not let go.
3. Gently let the step down; it will lock into place
automatically. Do not let the stainless tube hit or
rest on the drive or props at any time.
To raise the step:
Pull the plunger and raise the step at the same
time. Be careful when folding the step over onto the
platform. Do not allow the step to slam down.
Always make sure the area in the platform is clear
before closing the step.
A
Avoid injury or death. DO NOT overload
the flip down swim step. The swim step
maximum load is 400 lbs (181 kg).
30
-
S
ECTION
WARNING
24SD Owner's Manual
3
Advertisement
Table of Contents
