Table of Contents
Advertisement
M
AINTENANCE AND
2. Check propellers for damage. If bends, cracks
or other damage are found, consult your
authorized Cobalt dealer for service. Do not
continue to use badly damaged propellers.
Using damaged propellers may damage the
drive unit(s) within time.
Every 100 Hours
Clean the bilge area. Make sure all drain
passageways are clear. Refer to Bilge in Section 5
for cleaning instructions.
Monthly
A
DANGER
Avoid the risk of injury or drowning. The
ignition safety switch and lanyard are to
prevent the boat from becoming a
runaway if the operator is accidentally
thrown away from the helm. With the
engine(s) running, pull the lanyard off
the ignition safety switch. Engine(s)
must stop running. If the engine or
engines do not stop running,
immediately see your authorized Cobalt
dealer for service.
1. Test the GFCI outlet circuit breaker feature if
equipped. Push the TEST button on each
outlet. Power should be interrupted to all the
outlets onboard. Press the RESET button to
restore power. If power is not interrupted,
consult your authorized Cobalt dealer.
TEST
24SD Owner's Manual
RESET
COB_0079_A
T
ROUBLESHOOTING
2. Check condition of all self-sacrificing anodes. If
anode shows deterioration of 50% or more, it
must be replaced. Refer to the propulsion unit
operator's manual for additional information.
Quarterly
Have your authorized Cobalt dealer perform the
following scheduled maintenance:
1. Clean the freshwater filter.
2. Fill, pressurize and inspect the freshwater
system for leaks and proper component
operation.
3. Inspect the steering, shift and throttle systems
for proper operation.
4. Check all batteries for proper electrolyte level.
5. Check trim tab pump fluid level.
UNSCHEDULED
MAINTENANCE
A problem with a piece of equipment can occur at
any time. Be aware of a malfunction. Have a
problem serviced immediately by your authorized
Cobalt dealer.
Engine/Propulsion/Cooling System
If a problem occurs with your engine, propulsion
unit or the cooling system between the scheduled
maintenance cycle, immediately notify your
authorized Cobalt dealer. Do not allow a problem to
go unattended. By doing so, a minor repair could
become a major overhaul.
Electrical System
Have your authorized Cobalt dealer repair all
electrical problems. An electrical problem must be
treated seriously.
A
Avoid fire or explosion. Whenever
checking for electrical problems, use
extreme caution. Fuel and fumes are
extremely flammable and explosive.
6
3
-
DANGER
Advertisement
Table of Contents
