Table of Contents
Advertisement
Program Mode
The Split Function
There are four parameters (described below) that determine the behavior of the Split. Use the
cursor buttons to access each of the Split parameters for each active Zone.
Program
The Program parameter for Zone 2 determines the Program for the left-hand side of
the Split, also known as the "Split Program". This parameter is selected by default when
performing the Split function, and the default Split Program (245 Finger Bass) will be
selected. Choose a Split Program using the Category buttons, the Alpha Wheel, the Previous/
Next buttons, or enable the Keypad button and type an ID number followed by the Enter
button.
Volume
To change the volume of a Zone, use the cursor buttons to select the Volume parameter for
one of the Zones. To set a volume, use the Alpha Wheel, the Previous/Next buttons, or use
the keypad function of the Category buttons to type a volume (0-127) followed by the Enter
button.
Key Range
You can adjust the boundary between the left and right hand Programs on the keyboard by
adjusting the Key Range low and Key Range high parameters for each Zone. The keyboard
display for each Zone shows a visual indication of the Key Range by dimming keys that are
outside of the Key Range.
To change the Key Range of a Zone, use the cursor buttons to select the Key Range low or
Key Range high parameters for one of the Zones. Key Range low and Key Range high are
the left and right parameters, respectively, below the Key Range label. With one of these
parameters selected, set the Key Range by using the Alpha Wheel, the Previous/Next buttons,
or use the keypad function of the Category buttons to type a key number (0-127) followed
by the Enter button. With Key Range low or Key Range high selected, the value can also be
changed by holding the Enter button, then pressing the desired key.
6-14
Advertisement
Table of Contents
