Table of Contents
Advertisement
Multi Edit Mode
Zone Parameters
Enter + Controller
In Multi Edit Mode on the Controls page, when the Controller parameter is selected,
holding the Enter button and moving a controller (a Slider, Switch button, Mod Wheel or
Pedal) will jump to selecting that controller in the current Zone. This allows you to quickly
select a controller.
In a Controller destination field in Multi Edit Mode, Enter + Controller will assign the
Destination of the touched controller to the selected controller.
Using Enter + Controller in an OnValue or OffValue field or in an Entry Position or Exit
Value field, will set the value of that controller to the field value. For example if you want to
set an OnValue to a value of 100, you can hold Enter and move a controller to quickly set
OnValue to 100.
Enter + Key
In Multi Edit Mode, on the Overview page, with the Low Key Range or High Key Range
parameter selected, hold the Enter button and strike a key to set the Low Key or High Key.
This will also work on the Control page with a Switch selected, when Mode = Chord. The
value of the Key fields can be set using Enter + Key.
Zone Parameters
Each of the four Zones in a Multi has multiple parameters that determine its behavior. Since
the Zones of a Multi are independent of each other, changing a parameter for a certain
Zone will not affect the parameters of any other Zone. There are some exceptions to this,
for example, the parameters on the Common Page are common to all 4 Zones. Also, on the
Controllers Page for Switch Controllers, the parameters Type, Entry State, and Exit State
are common to all 4 Zones. Lastly, on the Controllers Page for Continuous Controllers, the
parameters Entry Position and Exit Value are common to all 4 Zones.
The top right corner of the display of the MAIN & CONTROLS pages shows the currently
selected Zone out of four Zones, or "All Zones" if the parameter applies to all Zones.
The Zone parameters for each page are explained in detail below.
9-5
Advertisement
Table of Contents
