Features Programming Checklist - Crime Guard 533i 3 Operation Manual

FEATURES PROGRAMMING CHECKLIST

This checklist will assist you when programming features. Before
attempting feature programming, please carefully read pages 20 and 21 for
the entire features programming details and instructions to become familiar
with the features and the programming procedure. A detailed explanation
of each of the programmable features is found on pages 22 through 32.
To best use this checklist, mark each applicable box with "\" next to the
feature to be changed before entering features Programming Mode. As each
feature is programmed, change its mark to "X".
To program features, follow these steps:
Step 1 - Turn the ignition "off", and press the Valet Switch 5
times.
(the system will respond a siren chirp, then briefly
sounding the siren and the Status Light begins
flashing)
Step 2 - Press the Valet Switch the same number of times as the
desired feature number.
(the system will acknowledge the Valet Switch entry
by repeating the same number of siren chirps and the
Status Light flashes an equal amount)
Step 3 - Press the transmitter's Large Upper Button to turn the
feature "on", or press the Small Lower Button to turn
the feature "off".
(turning the feature "on" is indicated by one siren
chirp and the Status Light being on; turning the feature
"off" is indicated by two siren chirps and the Status
Light being off)
Repeat - Steps 2 and 3 for each feature to be changed
Page 38