Table of Contents
Advertisement
Operation" setting, one of the transmitter's buttons will only Arm the
system, and a second button will only disarm the system. An optional
transmitter with four buttons, Omega part number #105-05, is available from
your Crime Guard dealer or directly from Omega Research and Develop-
ment. The following pages will show the system's operation with either type
of transmitter.
Programming Transmitter 1 Or 2 Button Operation:
Follow Steps 1 to 4 on page 20; at Step 4 the Valet Switch will be pressed
and released twenty two times. The system's response will be twenty two
siren chirps, and the Status Light flashing twenty two times, pausing, then
repeating. Within 10 seconds, press and release the transmitter's Large
Upper Button to configure the system for "1 Button Operation" (the siren
will chirp once) or the Small Lower Button to configure the system for "2
Button Operation" (the siren will chirp twice).
TRANSMITTER "2 BUTTON" OPERATION
Programmable feature #22 changes the configuration of how the trans-
mitter operates the system. In the factory default setting of "1 Button
Operation", a single transmitter button alternates Arming and Disarming the
system with every press of the button. When this feature is programmed to
the "2 Button Operation" setting, one of the transmitter's buttons will only
Arm the system, and a second button will only disarm the system. An
optional transmitter with four buttons is available; an order form is found on
page 36.
To Arm the System:
3 Button Transmitter
Press & Release the Large Upper Button
OR
Press & Release the "Arm/Lock" Button (
Optional 4 Button Transmitter
THE SIREN CHIRPS TWICE
TO CONFIRM ARMING
THE DOORS WILL LOCK*
* An optional doorlock interface must be installed
Page 32
THE PARKING LIGHTS
FLASH TWICE
TO CONFIRM
ARMING
)
Advertisement
Table of Contents
