Arming The System; How To Program Features; To Arm The System - Crime Guard 250i6 Owner's Manual

Arming the System

"Arming" places the system into a state whereby it will respond, or "activate" to any
detected intrusion attempt. The system may be Armed provided the ignition switch
is "off" and the system is not in Valet Mode.

To Arm the System:

Upon Arming: • The siren will chirp one time.
• If connected, the parking lights will flash once.
• The optional starter interrupt, if installed, will engage.
• If installed, the Status Indicator Light will begin to flash slowly.
• Another option is having the doors automatically lock when-
ever the system is armed. This requires connecting an opt-
ional interface (the Omega "DM-1").
Press & Release the Transmitter's
"Arm" Button.
THE SIREN WILL
CHIRP ONCE
THE PARKING LIGHTS
WILL FLASH ONCE
(IF CONNECTED)
Page 6

How to Program Features

The 6 programmable features, described on the previous two pages, are very
easily programmed by the following procedure:
Step 1: The system must be connected to power and ground, and be disarmed.
Step 2: Press and hold either transmitter's "Disarm" and button 3 together
for 4 seconds; the system will chirp 5 times confirming entry to Features
Programming Mode.
Step 3: Within 10 seconds of entering Features Programming Mode, press and
release the transmitter's Button 3 the number same of times that
equals the number of the feature to be programmed. After a pause, the
system will repeat the feature number with a like number of siren chirps.
Step 4: After the system acknowledges the feature to be programmed, press
either the "Arm" Button to turn the feature on (the system's response will
be 1 chirp), or the "Disarm" Button to turn the feature off (the system's
response will be 2 chirps).
Page 19