Disarming By Emergency Override - Crime Guard 533i 3 Operation Manual

DISARMING BY EMERGENCY OVERRIDE

Emergency Override:
In the event that your transmitter is lost, damaged, or its batteries have
become exhausted, the Valet Switch and the vehicle's ignition key may be
used to disarm the system. Please note that for this operation the pressing of
the Valet Switch may be customized; this is the SecureCode feature, the
programming of which is described on page 23.
The following Emergency Override instructions reflect the SecureCode
entry of the Valet Switch as the "as received" default setting of "1 press".
Instead of "1 press" of the Valet Switch, a customized programming of the
SecureCode would require from 2 to 12 presses.
To Disarm the System without using a Transmitter:
Step 1. With the system in the armed condition, enter the vehicle via the
driver's door (be aware that the system will activate to an alarm
condition when the door is opened).
Step 2. Using the ignition key, turn the vehicle's ignition on.
Step 3. Within 5 seconds, enter the SecureCode by pressing and releasing
the Valet Switch once. The system will disarm.
ENTER THE VEHICLE
AND USE YOUR KEY TO
TURN THE IGNITION ON
If the SecureCode entry of the Valet Switch is the "as received" default
setting of "1 press", the system will disarm the moment the Valet Switch is
released from the single press. If a customized SecureCode has been
programmed, the system will disarm a few seconds after the correct entry.
If an incorrect entry is made, the system will not disarm.
A procedure which separate, but similar, to an Emergency Override is the
Easy Valet mode, which prevents the system from performing any automatic
arming operations which may be programmed to occur. Easy Valet Mode
is explained on page 14.
THE SYSTEM WILL DISARM
Page 11
WITHIN 5
SECONDS OF
TURNING THE
IGNITION ON,
ENTER THE
SECURECODE BY
PRESSING THE
VALET SWITCH