Reviewing The Last Parameters; Reviewing Previously Stored Temperature Data; Reviewing Previously Stored Temperature Data (Os534E, Os523E, Os524E) - Omega Engineering OMEGASCOPE OS523E User Manual

2
Using the Handheld Infrared Thermometer

2.4.1 Reviewing the Last Parameters

°F

2.4.2 Reviewing Previously Stored Temperature Data

(OS534E, OS523E, OS524E)
°F
2-32
The thermometer stores the last temperature measured in
the real time mode (refer to Table 2-1). This temperature
can be recalled by pressing the
- Press the
FUNC
temperature data and parameters. You may review:
• MAX temperature
• MIN temperature
• dIF temperature
• AVG temperature
• TC temperature
• HAL temperature
• LAL temperature
• AMB temperature
• MEM location
You can review all 800 stored temperature values on the
thermometer display using the following procedure:
1. Press and hold the
Display Mode (MEM) appear.
2. Press the
press the
C
The memory location can be from 001 to 800.
3. Press the
the lower portion of the display. If there is no data stored
in a memory location, the display shows "----" .
If no keys are pressed, the thermometer goes into sleep
mode in approximately 5 seconds.
key to review the most recently stored
key until you see the Memory
FUNC
key to increment the memory location or
F key to decrement the memory location.
key. The stored temperature is shown in
LOCK
NOTE
key.
FUNC
Calculated values
Set values