Table of Contents
Advertisement
5
Hex M8*40 for the out cover
6
Bolt M18×1.5 for adding oil
5. If it is too high about the temperature of the oil in the reducer, please stop using
the vehicle and get help from your JOYNER dealer.
6. For some special reasons, you have to dismantle the drive halfshaft or change a
new one , please do the following:
a. Use a special tool to dismantle the drive halfshaft.
b. After dismantling, you must make sure that the
broken, else you must take the broken circlip out form the reducer. For the rear main
reducer, it's simple that using a piece of magnet to adsorb the broken circlip. For the
front main reducer, you must open the cover for out and take it out .
c.
After assembling, you must make sure that the halfshaft can't be pulled out by hand.
The front and rear main reducer are important parts to the vehicle .If you have some problems
which you can't resolve by yourself, please get help from your JOYNER dealer.
17~25
45~55
circlip of the drive halfshaft is not
69
Advertisement
Table of Contents
