Engine Coolant - Joyner JNSZ650UV4S Owner's Manual

Hide thumbs Also See for JNSZ650UV4S:
Table of Contents

Advertisement

b. Remove the iron dust plug, this plug has a magnet on it. Iron dust caused by
moving parts will stick to the plug. Clean the iron dust from this dust plug.
d. Tighten the transmission oil outlet plug and the iron dust plug.
e. Remove dipstick of transmission, fill oil (GL-4 85W/90) about 1.9 liters.
f. Insert the transmission dipstick, check the oil level in the transmission. Confirm
the corrective oil level in the transmission.
Check transmission oil
If the color of transmission oil changes, you need to replace oil. Replace transmission
oil as above.

Engine Coolant

You must check the coolant for level and leaks. If it is low, you need to refill coolant
into the radiator (approximately 4000 ml). The lack of coolant will cause the engine to
overheat. This can cause engine damage.
The coolant should always be topped up, since the coolant can evaporate.
Put the vehicle on level ground.
1. Turn the coolant cap counterclockwise and open the cap.
2. Pour fresh coolant to filler neck.
3. Start the engine at idle.
4. Increase the engine rev a few times
5. Repeat 2,3,4 till the coolant is at neck and no bubbles come up.
6. Refit the coolant cap, turn it clockwise and tighten it
7. Turn the reserve coolant case cap counterclockwise and open the cap.
8. Pour fresh coolant of the specified type into the reserve coolant tank till the
coolant reaches 2/5 to 3/5 of the reserve coolant tank volume.
9. Close the reserve coolant case cap, turn it clockwise and tighten it
Top up the reserve coolant
47

Advertisement

Table of Contents
loading

Table of Contents