Messages Displayed On The Client Computer - Ricoh MP W7100 User Manual

9. Troubleshooting
Message
"Exceeded max. page
capacity per file. Press
[Write] to write the scanned
data to the memory storage
device, or press [Cancel] to
delete."
"Memory is full. Press [Write]
to write the current scanned
data to the memory storage
device, or press [Cancel] to
delete."

Messages Displayed on the Client Computer

This section describes likely causes of and possible solutions for the main error messages displayed on
the client computer when you use the TWAIN driver. If a message not described here appears, follow
the instruction.
Message
"Any of Login User Name,
Login Password or Driver
Encryption Key is incorrect."
"Authentication succeeded.
However, the access
privileges for scanner
function has been denied."
"Exceeded the maximum
number of scan modes to
save. Reenter after deleting."
168
Cause
The scan could not be
completed because the
maximum number of pages
that can be scanned by this
machine was exceeded
during the scanned data
was written to the memory
storage device.
The scan could not be
completed because there
was insufficient hard disk
memory when the scanned
data was saved to the
memory storage device.
Cause
The entered login user
name, password, or driver
encryption key was invalid.
The logged in user name
does not have permissions
for scanner function.
The maximum number of
registrable scan modes has
been exceeded.
Solution
Reduce the number of documents to be
written to the memory storage device,
and then try again.
Specify whether or not to save the
scanned document to the memory
storage device.
Solution
Check your login user name, login
password, or driver encryption key,
and then enter them correctly. For
details about login user name, login
password, and driver encryption key,
see Security Guide.
For details about how to set
permissions, see Security Guide.
The maximum number of modes that
can be stored is 100. Delete unneeded
modes.