Ricoh MP W7100 User Manual page 24

2. Getting Started
3. Control panel
See page 27 "Guide to the Names and Functions of the Machine's Control Panel".
4. Scanner cover
This protects the original feed mechanism and the scanning glass.
5. Scanner cover release lever
Use to open the scanner cover to clear jammed originals or to clean the machine.
6. Front output auxiliary tray
This can be used to receive delivered copies.
7. Front Cover
Open this cover to replace toner.
8. Main power switch
To operate the machine, the main power switch must be on. If it is off, turn the switch on.
See page 41 "Turning On/Off the Power".
9. Earth Leakage Breaker
To prevent electric shock this machine has an earth leakage breaker. The earth leakage breaker is normally in
the on position.
If the power does not come on, check if the earth leakage breaker is in the off position. If so, do not turn it to
the on position.
Contact your sales or service representative immediately.
10. Upper tray
Stores Paper Roll 1 (foreside) and Paper Roll 2 (inner side).
11. Anti-condensation heater switch
If condensation forms inside the machine as a result of temperature change, the machine may not print
properly. To minimize this problem, use the anti-condensation heater.
12. Paper roll tray (optional) or Cut paper trays (optional)
The illustration shows the cut paper trays.
Stores Paper Roll 3 (foreside) and Paper Roll 4 (inner side) if the paper roll tray is attached.
If the cut paper tray is attached, it stores the cut paper in Tray 3 (top tray) and Tray 4 (bottom tray).
13. [Scanner Stop] key
Use if originals are feeding in slanted, or to cancel scanning while an original is feeding in. You can also use
this to release the paper edge hold function.
14. Original table
Place originals here scanning side up.
15. Original guide
Set to the width of your originals.
16. Imaging unit release lever
Use this lever to open the imaging unit when clearing paper jams inside or cleaning the machine.
22