Toshiba PORTEGE M300 Maintenance Manual page 214

3.32 SETUP
(b) Network Boot Protocol
Use this option to set the starting method via a network.
PXE Sets to PXE protocol. (Default)
RPL Sets to RPL protocol.
7. Display
This group of options configures the computer's display.
(a) Power On Display
This option is used to select the display when booting up.
Auto-Selected
LCD+AnalogRGB
NOTE: When starting the computer in Standby or Hibernation, the last configuration is
saved. If data does not appear on the display you are using after starting in
Standby or Hibernation, pressing Fn+F5.
Pressing Fn+F5 changes the display setting as follows in order: the internal
LCD, the external CRT, both the internal LCD and the external CRT.
When an external CRT display, which does not support SVGA mode is connected
and "LCD+AnalogRGB" is selected, the external display is not displayed.
(b) LCD Display Stretch
LCD Display Stretch enables or disables a larger display area of the screen.
Enabled
Disabled
8. Others
Whether or not you need to configure the computer with these options depends
primarily on the kind of software or peripherals you use.
(a) Power-up Mode
Use this option to choose between resume and boot mode.
Boot
Resume
3-102
Selects an external monitor if one is connected.
Otherwise it selects the internal LCD. (Default)
Selects both the internal LCD and the external CRT for
simultaneous display.
Enables the LCD display stretch feature. (Default)
Disables the LCD display stretch feature.
Turns on boot mode. (Default)
Turns on resume mode.
PORTEGE M300 Maintenance Manual (960-504)
3 Tests and Diagnostics