Tools Required - Audiovox MMD102 Manual

TOOLS REQUIRED

- #2 Phillips Screwdriver
- #1 Phillips Screwdriver
- Utility or Razor Knife or Shears
- Wire Strippers
- Upholstery hook tool (for removal of panels as necessary)
- Electrical Tape
- Masking Tape
- Multimeter (to verify 12 volt DC and continuity: Do not use a test light or logic probe)
- Marker pen – to mark headliner
- Scribe (to mark trim ring if used)
- Misc. electrical connectors (to connect to vehicle power source). Requirements will
vary from vehicle to vehicle.
- DVD movie disc to verify system operation aftre installation.
GENERAL INSTALLATION APPROACH
1) Decide upon system configuration and options that will be installed (i.e.: what com-
ponents, VCP, Tuner, remote headphones, DVD, etc.).
2) Review all manuals to become familiar with electrical requirements and hook ups.
3) Decide upon mounting locations of all components and method of mounting.
4) Prep the vehicle by removing any interior trim necessary to gain access to vehicle's
wiring as well as all areas where interconnecting wire harnesses will need to be loca-
ted. If any access holes need to be cut into the vehicle (headliner, other trim components
etc.), this should be done now as well.
18