Adjusting The Chain Tension - KTM 1190 ADVENTURE Owner's Manual

13 SERVICE WORK ON THE CHASSIS
13.10

Adjusting the chain tension

Warning
Danger of accidents Danger caused by incorrect chain tension.
–
If the chain is too taut, the components of the secondary power transmission (chain, engine sprocket, rear sprocket, bearings in
the transmission and in the rear wheel) will be under additional load. In addition to premature wear, this can cause the chain
or the countershaft of the transmission to break in extreme cases. If the chain is too loose, however, it may fall off the engine
sprocket or rear sprocket and block the rear wheel or damage the engine. Ensure that the chain tension is correct and adjust it
if necessary.
Main work
–
Shift the transmission to idle
–
In the area in front of the chain guide, push the chain up and determine chain ten-

sion .
Info
The upper part of the chain
Chain wear is not always even, so you should repeat this measurement at differ-
ent chain positions.
401664-10
Chain tension
» If the chain tension does not meet the specification:
–
Adjust the chain tension. (
Finishing work
(Option: Center stand)
–
Remove the vehicle from the center stand. (
.

must be taut.
40... 45 mm (1.57... 1.77 in)
p. 112)
p. 106)
112